[okl4-developer] Need help in compiling

[Nelson Tam]

Hi,

On 21/03/2008, at 2:15 PM, neohtm wrote:
> I'd connected the USB-RS232 converter from the system to my laptop.  
> Then I
> had opened the serial terminal the Putty in Windows from my laptop.  
> But the
> system seems still the same...is there anything I forget to do?? 
> Sorry for
> these kind of newbie question.


Is Putty listening in to the serial port with the correct parameters?

Please read Section 3.7 of the Putty documentation:

http://the.earth.li/~sgtatham/putty/0.60/puttydoc.txt

The serial parameters are:

Baud rate (Speed): 115200
Data bits:  8
Parity bit: none
Stop bits:  1
Flow control: none

Serial line should correspond to the USB port your adaptor is  
connected to.  See if your Windows' "Hardware Profile" control panel  
helps you there (don't exactly remember what it's called, but it's  
been a while since I've used Windows... :)
--
(nt)

Nelson Tam
nelson at ok-labs.com